Konica Minolta Xt 用户手册
103
Pictures are
not sharp.
not sharp.
Make sure the subject is within
the autofocus range (p. 26).
the autofocus range (p. 26).
A special situation is pre-
venting the autofocus sys-
tem from focusing (p. 27).
venting the autofocus sys-
tem from focusing (p. 27).
Use the focus-lock function to
focus on an object at the same
distance as the subject (p. 26).
focus on an object at the same
distance as the subject (p. 26).
Pictures are
taken indoors
or in low-light
situations with-
out flash.
taken indoors
or in low-light
situations with-
out flash.
Slow shutter speeds
result in blurred images
when the camera is hand-
held.
result in blurred images
when the camera is hand-
held.
Use a tripod, change the cam-
era sensitivity to a higher set-
ting (p. 47), or use the flash (p.
28).
era sensitivity to a higher set-
ting (p. 47), or use the flash (p.
28).
The subject is beyond the flash range
(p. 47).
(p. 47).
Move closer to the subject or
change the camera sensitivity
to a higher setting (p. 47).
change the camera sensitivity
to a higher setting (p. 47).
Problem
Symptom
Cause
Solution
Focus signal is
red.
red.
While using
flash, the pic-
tures are too
dark.
flash, the pic-
tures are too
dark.
Shutter will
not release.
not release.
Card-locked
warning
appears on the
monitor.
warning
appears on the
monitor.
Memory card is locked.
Unlock the memory card using
the write-protect switch (p. 19).
the write-protect switch (p. 19).
Subject is too close.
Subject
appears too
far to the right
in the image.
appears too
far to the right
in the image.
Viewfinder was used for framing. Parallax is
apparent with subjects closer than 1m (3ft.)
at the zoom’s wide-angle position or 3m
(10ft) at the telephoto position.
apparent with subjects closer than 1m (3ft.)
at the zoom’s wide-angle position or 3m
(10ft) at the telephoto position.
Only use the LCD monitor for
framing with close subjects.
framing with close subjects.