Zebra Technologies 45537L-005 用户手册
135
Frequently Asked Questions
FAQs
04/21/2009
ZebraNet PrintServer II User Guide
45537L-005
What if a print job makes it to the
queue, but never leaves the queue?
The label does not print.
queue, but never leaves the queue?
The label does not print.
These are the things to check:
•
Confirm that the printer is turned on and
receiving power.
receiving power.
•
Confirm that the network cable is plugged in
and that you can ping the printer.
and that you can ping the printer.
If the above bullets do not change the outcome, it is
likely that there was a misconfiguration while
creating the queue. The queue must be recreated
verifying the following:
likely that there was a misconfiguration while
creating the queue. The queue must be recreated
verifying the following:
•
Confirm that you use the print server’s valid
IP address.
IP address.
•
If you are using a UNIX or AS/400 host,
there is an option for the remote queue
name. There is only one valid response to
use: PORTLF1.
there is an option for the remote queue
name. There is only one valid response to
use: PORTLF1.
•
If Windows does not have LPR installed, the
above required option should be left blank.
above required option should be left blank.
•
See the documentation for other operating
system specific queue creation.
system specific queue creation.
What are the minimum requirements
to network a printer?
to network a printer?
•
Cat-5 network cable with 10BASE-T
connectors
connectors
•
PSII
•
Hub or Switch
•
If a hub or switch is NOT used, you need a
cross-over cable.
cross-over cable.
•
Workstation running a TCP stack with print
services installed
services installed
What do the activity lights on the PSII
mean?
mean?
•
Fast blinking (9 times/second) — no link status
•
Slow blinking (1 time/second) — no IP address,
or the unit is sending data to the parallel port
or the unit is sending data to the parallel port
•
Blinking red — unit is still in POST
•
red-green-red-green — unit is in Netware
firmware update mode
firmware update mode
•
red-red-green-green — unit is in IP firmware
update mode
update mode
•
Solid red — unit has failed POST. Remove
network cable and restart printer
network cable and restart printer
What is the default User ID and
password for the print server?
password for the print server?
•
The User ID is admin and the password is 1234.
Question
Answer