Epson DX6000 用户手册

Before using this product, read and follow these 
safety instructions:

■

Use only the power cord that comes with the 
product. Use of another cord may cause fire or 
shock. Do not use the cord with any other 
equipment.

■

Make sure the power cord meets all relevant 
local safety standards.

■

Use only the type of power source indicated on 
the label.

■

Place the product near a wall outlet where the 
power cord can be easily unplugged.

■

Do not let the power cord become damaged or 
frayed.

■

If you use an extension cord with the product, 
make sure the total ampere rating of the devices 
plugged into the extension cord does not exceed 
the cord’s ampere rating. Also, make sure the 
total ampere rating of all devices plugged into 
the wall outlet does not exceed the wall outlet’s 
ampere rating.

■

Avoid locations that are subject to rapid changes 
in heat or humidity, shocks or vibrations, or 
dust.

■

Leave enough room around the product for 
sufficient ventilation. Do not block or cover 
openings in the case or insert objects through the 
slots.

■

Do not place the product near a radiator or 
heating vent or in direct sunlight.

■

Place the product on a flat, stable surface that 
extends beyond its base in all directions. It will 
not operate properly if it is tilted or at an angle. 

■

Make sure the back of the product is at least 
10 cm away from the wall.

■

Do not open the scanner unit while copying, 
printing, or scanning.

■

Do not spill liquid on the product.

■

Do not use aerosol products that contain 
flammable gases inside or around the product. 
Doing so may cause fire.

■

Except as specifically explained in your 
documentation, do not attempt to service the 
product yourself.

■

Unplug the product and refer servicing to 
qualified service personnel under the following 
conditions: if the power cord or plug is damaged; 
if liquid has entered the product; if the product 
has been dropped or the case damaged; if the 
product does not operate normally or exhibits a 
distinct change in performance. Adjust only 
those controls that are covered by the operating 
instructions.

■

When storing or transporting the product, do not 
tilt it, stand it on its side, or turn it upside down; 
otherwise ink may leak from the cartridges.

■

Be careful not to trap your fingers when closing 
the scanner unit.

■

Keep ink cartridges out of the reach of children 
and do not drink the ink.

■

Be careful when you handle used ink cartridges; 
there may be ink remaining around the ink 
supply port. If ink gets on your skin, wash it off 
with soap and water. If it gets in your eyes, flush 
them immediately with water. If you still have 
discomfort or vision problems, see a doctor 
immediately.

■

Do not put your hand inside the product or 
touch any cartridges during printing.

■

Install a new ink cartridge immediately after you 
remove an expended cartridge. Leaving 
cartridges uninstalled can dehydrate the print 
head and may prevent the product from 
printing.

■

If you remove an ink cartridge for later use, 
protect the ink supply area from dirt and dust 
and store it in the same environment as the 
product. Note that there is a valve in the ink 
supply port, making covers or plugs 
unnecessary, but care is needed to prevent the 
ink from staining items that the cartridge 
touches. Do not touch the ink cartridge, ink 
supply port, or surrounding area.