Panasonic AG-HVX200AP 用户手册

AUTO

MANUAL

CAMERA

MCR

VCR

DUB

PC

ON

•  Check that the mode lamp (CAMERA) is 

lighted red. If not, press the mode button.

to select auto mode.
•  “A” appears on the viewfinder and LCD 

screens.

•  The focus, gain, iris and white balance are 

adjusted automatically.

POWER switch to start shooting.
•  Press again to return to the camera to the 

shooting standby mode. 

•  Use the handle START/STOP button to make 

it easier to shoot from low angles.

Under the following circumstances, even if you 
press the STOP button it may take some time until 
the writing to the P2 card finishes. For this reason, 
the operation will not be acknowledged if you press 
the START button too soon.
•  Stopped after only a short recording time
•  Stopped immediately after the recording has 

moved to a second P2 card

•  There are two card slots.
•  Be absolutely sure to close the card slot 

covers to keep the dust out.

•  Do not remove the P2 card while the P2 card 

access lamps are blinking orange. (Page 26)

P2

TAPE

ON

Do not operate the MEDIA switch when the power 
is switched ON.
If you attempt to operate the MEDIA switch, the 
message “TURN POWER OFF” will be displayed.
In this case, switch OFF the power, and then switch 
it ON again.