Teledyne T100 用户手册

198 

When the analyzer is in either Dual or Auto Range modes the user must run a separate 
calibration procedure for each range.  After pressing the CAL, CALZ or CALS buttons 
the user is prompted for the range that is to be calibrated as seen in the CALZ example 
below: 

Continue Calibration as per 

Standard Procedure 

SAMPLE          RANGE = 500.000 PPB        SO2 =XXX.X   
 

 < TST  TST >  CAL

 

   CALS

 

 

SETUP

 

        RANGE = 500.000 PPB    SO2 =XXX.X 

  

 < TST  TST >  

      

 

 

EXIT

 

Or until the 

reading 

stabilizes and 

the ZERO button 

is displayed 

 SAMPLE  

LOW  

ENTR SETUP

 

 SAMPLE  

LOW   HIGH

 SETUP

 

Analyzer enters 

 Mode 

Refer to Table 6-1 for 

Z/S Valve States 

during this operating 

mode. 

 

Once this selection is made, the calibration procedure continues as previously described 
in Sections 7.2 through 7.6.  The other range may be calibrated by starting over from the 
main SAMPLE display. 

Contact closures for controlling calibration and calibration checks are located on the rear 
panel CONTROL IN connector. Instructions for setup and use of these contacts can be 
found in Section 8.1.2. 

When the appropriate contacts are closed for at least 5 seconds, the instrument switches 
into zero, low span or high span mode and the internal zero/span valves will be 
automatically switched to the appropriate configuration. The remote calibration contact 
closures may be activated in any order. It is recommended that contact closures remain 
closed for at least 10 minutes to establish a reliable reading; the instrument will stay in 
the selected mode for as long as the contacts remain closed. 

06807C DCN6650