Panasonic VDR-D105 用户手册

下载
页码 108
33
LSQT1040
Se
tu
p
Setting date and time
Setting date and time
If the screen shows the incorrect date/time, then adjust it.
¬Rotate the mode dial to select 
.
1 Press the MENU button, then select [
BASIC] 
# 
[
CLOCK SET] 
# [YES] and press the joystick.
2 Move the joystick left or right to select the item to be 
set. Then, move the joystick up or down to set the 
desired value.
≥ The year will change as follows:
2000, 2001, ..., 2099, 2000, ...
≥ The 12-hour system is used to display the time.
3 Press the joystick to enter the selection.
≥ After pressing the MENU button to finish the setting, check the date and time display.
≥ The clock function starts at [00] seconds.
∫ Changing the display style
Press the MENU button, then select [
SETUP] 
# 
[
DATE FORMAT] 
# desired display style and press the joystick.
∫ Changing the date and time display style
Press the MENU button, then select [
SETUP] 
#  [
DATE/TIME] 
# desired display style and press the joystick.
≥ The date and time function are driven by a built-in 
lithium battery.
≥ Make sure to check the time before recording.
≥ If [
0] or [- -] is indicated when this unit is turned 
on, then the built-in lithium battery runs down. After 
charging the battery using the steps below, set the 
clock.
Connect the AC adaptor to this unit or place the 
battery on this unit, and the built-in lithium battery 
will be recharged. Leave this unit as is for approx. 
24 hours, and the battery will save the date and time 
for approx. 6 months. (Even if the OFF/ON switch is 
set to OFF, the battery is still being recharged.)
Display 
style
Y/M/D
M/D/Y
D/M/Y
Screen 
display
3:30 PM
2006.12.15
3:30 PM
12.15.2006
3:30 PM
15.12.2006
[DATE]
[D/T]
[OFF]
  3:30 PM 
12.15.2006
12.15.2006
D105(P)eng.book  33 ページ  2006年1月16日 月曜日 午後4時1分