Panasonic PV-DV402 用户手册

PLAY

PAUSE

PLAY

STOP

REC

High quality digital-to-digital copying can
be accomplished if both Palmcorders
incorporate the DV Input/Output (i.LINK)
Connector (DV interface cable (i.LINK) is
not supplied).

Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.

Insert a blank tape with the record
tab closed into the target (recording)
Palmcorder and set POWER to VCR.

Press   (PLAY) on the source
Palmcorder. When the tape reaches
the point you want to start dubbing,
press   (PAUSE).

Hold down REC and press   (PLAY)
on the target (recording) Palmcorder or
on the remote control.
Press   (PAUSE) to pause the tape at
the starting point of the dub.

Simultaneously, press   (PAUSE) on
both units to begin dubbing.

Press   (STOP) on the recording
unit, and then press   (STOP) on the
playing unit to end dubbing.

• When two Palmcorders are used for

dubbing, it is recommended that the
Remote Control VCR1 or VCR2 setting be
used to avoid improper-operation.

• When two Palmcorders are connected

using the DV interface cable (i.LINK) (not
supplied), a Video Editing Controller
cannot be used.

• Do not connect both an S-Video Cable or

A/V Cable and a DV Interface Cable
(i.LINK).

Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.

DV Interface
Cable (i.LINK)
(optional)

DV Input/Output
(i.LINK) Connector

PAUSE

• Connect both Palmcorders to their

power sources.

• Connect the two Palmcorders using the

DV interface cable (i.LINK)
(4-pin to 4-pin).

• Turn both Palmcorders ON.

STOP

REC

51