Sharp VL-NZ10S 用户手册

TAPE-CAMERA

• Before you start recording, perform the opera-

tions described on pages 9 through 18 to
prepare your camcorder for recording.

Remove the lens cap.

Set the Media Selection
switch to TAPE.

Hold down the Lock button and set the
Power switch to CAMERA.

• The picture from the lens is now

displayed on the screen.

• The camcorder is now ready to record

(Recording Standby mode).

Note:
• If “AUTO” is not displayed at this time, set

the camcorder to Full Auto mode (see page
54).

Press the REC START/STOP button to
begin recording.

Press the REC START/STOP button again.
Recording pauses, and the camcorder enters
Recording Standby mode.

Set the Power switch to OFF without pressing
the Lock button.

Notes:
• Battery power is consumed in Recording

Standby mode. Turn off the power if you will not
be recording again soon.

• If the camcorder remains in Recording Standby

mode for more than 5 minutes in TAPE-CAMERA
mode, the power will automatically turn off to
save battery power and to protect the tape from
being damaged. To resume recording, set the
Power switch to OFF and then back to CAMERA.
(The camcorder will make a confirmation sound
when it is left in Recording Standby mode for
about 4 minutes.)

BT-L225

BT-L445

approx.

1hr. 30min.

approx.

50min.

approx.

3hr.

approx.

1hr. 40min.

Note:
• Using the zoom (see page 21) and other

Lock button

Media Selection switch

Power switch

REC START/STOP button