Sharp VL-NZ10S 用户手册
ii
Inserting a Cassette
1
Attach the power source to the
camcorder, then slide the cassette
compartment door release and open the
cassette compartment door.
camcorder, then slide the cassette
compartment door release and open the
cassette compartment door.
2
Insert a commercially available cassette
fully with the window facing outwards,
and with the erasure protect tab facing
upwards.
fully with the window facing outwards,
and with the erasure protect tab facing
upwards.
3
Press the W mark gently until the
cassette holder clicks into place.
cassette holder clicks into place.
4
Wait for the cassette holder to fully
retract. Close the compartment door by
pressing the centre until it clicks into
place.
retract. Close the compartment door by
pressing the centre until it clicks into
place.
SA
VE
RE
C
Inserting a Card
1
Make sure that the Power switch is set
to OFF.
to OFF.
2
Slide the card slot cover release and
open the card slot cover in the direction
of the arrow.
open the card slot cover in the direction
of the arrow.
3
Insert a card into the slot as shown
below, and push it in as far as it will go.
below, and push it in as far as it will go.
4
Close the card slot cover.
Note:
• You can use an SD Memory Card (commer-
• You can use an SD Memory Card (commer-
cially available) and a MultiMediaCard (only
supplied with VL-NZ10) for storing still
images with this camcorder, not a
SmartMediaE card or Memory StickE media.
In this operation manual, “card” refers to the
SD Memory Card or the MultiMediaCard.
supplied with VL-NZ10) for storing still
images with this camcorder, not a
SmartMediaE card or Memory StickE media.
In this operation manual, “card” refers to the
SD Memory Card or the MultiMediaCard.
Cassette compartment
door release
W mark
Erasure protect tab
Card slot cover release
Clipped corner
Label