Sharp VL-NZ100S 用户手册

The supplied lithium battery is used to store the
memory of the date and time settings.

Slide the cassette compartment door
release and open the cassette compart-
ment door.

Note:
• The cassette holder will extend and open

when the camcorder is connected to a
power source. Be sure to close the cassette
holder before proceeding to the next step
(see page 12).

Pull out the lithium battery holder using
a pointed object such as the tip of a
ballpoint pen.

Insert the lithium
battery into the
battery holder with
the H side of the
battery facing the
m

 side of the

holder.

Push the battery holder back into
position. Press the W mark gently,
then close the cassette compartment
door by pressing the centre until it clicks
into place.

Perform steps 1 and 2 above,
then lift out the battery from
the battery holder.

• Do not short-circuit, recharge, disassemble, or

heat the lithium battery.

• Should the lithium battery leak, wipe the battery

compartment clean, and then insert a new
battery.

• The lithium battery will last about one year under

normal usage.

CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recom-
mended by the equipment manufacturer.
X

 KEEP THIS BATTERY AWAY

FROM CHILDREN. IF SWALLOWED,
CONSULT A PHYSICIAN IMMEDIATELY FOR
EMERGENCY TREATMENT.
Z

 BATTERY MAY EXPLODE IF

MIS-USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.

Lithium battery

holder

“m” mark

VL-NZ100H-009-018

02.2.14, 9:58 AM

14