American Standard Single Control Kitchen Pull-Out Faucet 用户手册

M 9 6 8 4 7 3   R E V   1. 8

Move HANDLE (1) down into 

"off" position.

With HANDLE (1) down in "off" position,

Turn on water supplies.

Operate handle up and down, in COLD and HOT positions,

to flush water lines thoroughly.

Place WASHER (7) into HOSE END (4) and

connect  HAND SPRAY (2) to HOSE END (4).

Place HAND SPRAY (2) back into faucet.

pull HAND SPRAY (2) from FAUCET (5)

and disconnect HAND SPRAY (2). Be 

careful not to lose WASHER (7). Pull

HOSE (3) (HOSE should pull approximately 

2 feet) and direct open HOSE END (4)

into sink.

Check HAND SPRAY (2) operation:

With faucet on push BUTTON (6) for a broad cleansing

spray. BUTTON (6) will lock into this position.

With HAND SPRAY (1) seated in FAUCET (2), 

install WEIGHTS (4) onto HOSE (3) using two

SCREWS (5). Locate the WEIGHTS (4) two feet (2')

from the underside of the sink deck.

Tighten SCREWS (5) firmly. 

Check connections for leaks.

Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly

to wall supplies. Connection on fitting

supplies are 3/8" compression. Connect

left supply (Marked with a Red Stripe) to Hot

and right supply (Marked with Blue Stripe) to 

Cold wall supply. Use adjustable wrench to 

tighten connections. Do not over tighten.

Faucet supplies are 21" long from faucet base.

To unlock BUTTON (6), rotate BUTTON (6) left or right

using the TAB (8). Faucet will return to standard spray.

24"