Panasonic DMP-BD80GN 用户手册

RQT9407

The following messages or service numbers appear on the television or unit’s display when something unusual is detected during startup and 
use.

≥[DivX]

:

 You are trying to play the DivX VOD content that was purchased with a different 

registration code. You cannot play the content on this unit. 

≥You inserted an incompatible disc.

≥You tried to play a non-compatible image.

≥Confirm “SD” on the unit’s display is not blinking and re-insert the card.

≥The disc may be upside down.

≥[DivX]

:

 The DivX VOD content has zero remaining plays. You cannot play it. 

$ This operation is not 

≥Some operations are unsupported by the unit. For example;
– [BD-V]

: 

During play back, reverse slow-motion or reverse frame-by-frame is not possible.

$ This operation is prohibited 

≥Depending on the disc, you may not be able to perform search or skip when film previews 

and warning screens are being played back.

≥When a hub is used but its Link lamp does not light up, check the cable connection, LAN 

terminal connection, cable itself (a cross cable may be used by mistake), etc.

≥The “IP Address” in “IP Address / DNS Settings” is “---. ---. ---. ---“. Set the “IP Address”, 

“Subnet Mask”, and “Gateway Address“. (Select the automatic address acquisition if 

necessary.)

≥If you use a hub, then check the connection between the hub and the router.

– Use the UPLINK port of the hub to connect to a router.

– Check whether or not the hub’s Link lamp lights up. If it does not light up, then check the 

cable connection, LAN terminal connection, cable itself (a cross cable may be used by 

mistake), etc.

≥If the above conditions are OK, then the router may not operate in DHCP mode. Check the 

router settings and operation. You may reset the router to restore it to normal.

≥This unit’s IP address is used by another device. Check the IP addresses of this unit, 

personal computers, and routers, etc. If necessary, reconfigure them to avoid IP 

addresses from being duplicated.

≥Turn the unit off. Remove the AC mains lead and reconnect it and try again. If the same 

symptom persists, then consult your dealer.

≥If you use a hub, then check the connection between the hub and the router.

– Use the UPLINK port of the hub to connect to a router.

– If the hub’s Link lamp does not light up, then check the cable connection, LAN terminal 

connection, cable itself (a cross cable may be used by mistake), etc.

≥Check the “IP Address”, “Subnet Mask”, and “Gateway Address” in the “IP Address / DNS 

Settings”.

≥If the MAC address information is required, then press [SETUP] to display the “Network 

Settings” menu.

≥When you set “BD-Live Internet Access” to “Limit” and play BD-Live contents which do not 

have a content owner certificate, the Internet access of the content is not allowed. If you 

allow the content to connect to Internet, set “BD-Live Internet Access” to “Permit”.

≥The firmware download server is currently unavailable. Please try again later.

≥[BD80] “High Clarity Sound” in setup menu is set to “Enable”, and “High Clarity Sound” in 

on-screen menu is set to “On”.

RQT9407~Body_mst.fm  36 ページ  ２００９年２月２３日　月曜日　午後８時９分