Philips 1VMN30256A 用户手册

EN

• Press to turn on the unit, or to turn the unit into the 

standby mode. (To completely turn off the unit, you 
must unplug the AC power cord.)

• Press and hold for 10 seconds to shut down the unit.
• This button lights up in red when the unit is in 

standby mode and turns off when the power is on.

• Press to stop playback.

• Press to pause playback.

• Press to start or resume playback.

• Press to open or close the disc tray.

• Place a disc after opening the disc tray.

• Refer to “Front Panel Display” on page 14.

• Receive signals from your remote control so that you 

can control the unit from a distance.

• Insert an SD Memory Card and play back the 

contents in it.

• Use to connect to a display with an HDMI compatible 

port with an HDMI cable.

• Use to connect to network provisioning equipment 

such as a router or a modem with a LAN cable.

• Use to connect a TV monitor, an AV receiver / 

amplifier or other device with an RCA audio cable.

• Use to connect a TV monitor with component video 

inputs with an RCA component video cable.

• Connect to a standard AC outlet to supply power to 

this unit.

• Unplug this cord from the AC outlet to completely 

turn off the unit.

• Use to connect an AV receiver / amplifier, Dolby 

Digital / DTS decoder or other device with a digital 
audio coaxial input jack with a digital audio coaxial 
cable.

• Use to connect a TV monitor, an AV receiver / 

amplifier or other device with an RCA video cable.

• Due to new ENERGY STAR® requirements, this unit 

will automatically enter standby mode after 25 
minutes of inactivity.

• Do not touch the inner pins of the jacks on the rear 

panel. Electrostatic discharge may cause permanent 
damage to the unit.

• This unit does not have the RF modulator.
• Do not try to rip the internal Wireless LAN from the 

unit.