Toshiba BDX2000KC 用户手册

FUNCTION SETUP

Set up the network connection settings in order to use the
BD-Live function with a BD-Live disc.

After you made IP address/DNS settings or when a LAN
cable is connected, always perform the connection test
to check if the connection is correctly made.

In stop mode, press [SETUP].

Use [K / L] to select

, then press [ENTER].

Use [K / L] to select “Others”, then press
[ENTER].

Use [K / L] to select “Network Connection”,
then press [ENTER].

Use [K / L] to select “Connection Test”, then
press [ENTER].

Connection test will start automatically and the test result
will appear right after the connection test finishes.

• “Testing...” : The test is in progress.
• “Pass”

: Connection test is successfully completed.

• “Fail”

: Connection test failed.

Check the connection settings.

Press [ENTER] to go to the list of network status
confirmation screen.

Press [ENTER] to go back to the previous
screen, or press [SETUP] to exit.

Network settings are set to the following settings initially.
(In most cases, you can connect to the Internet without
making any changes to the default settings.)

If you want to set the network settings back to the default
settings as above (except “BD-Live Setting”), follow the
procedure below.

Follow steps 1 to 4 in “Connection Test” on this
page.

Use [K / L] to select “Enable(Easy)”, then press
[ENTER].

• The unit will start the connection test automatically

and the test result will appear right after the test
finishes.

• After the connection test finishes, press [ENTER] to go

to network status confirmation screen.

Press [ENTER] to activate the network settings
and set the network connection automatically.
Press [SETUP] to exit.

In following cases, select “Enable(Custom)” to set each
setting as necessary.

- When connection test failed with the setting of

“Enable(Easy)”.

- When instructed by your Internet service provider to