SVAT Electronics CV301-8CH 用户手册

CV301-8CH

now you can see

• 

Sometimes your router will not allow you to view the footage with 

your external IP address because the DVR is hooked up to the same 

router. Try putting the DVR’s internal IP address in the address bar and 

try to connect

• 

See the network set up section for set up instructions

•          If using a Port other than 80 add it to the end of the IP address

• 

Port Forwarding may not be set up correctly

• 

The external IP address of the DVR may have changed. Try setting 

up the DDNS account to always be up to date with the latest IP 

information 

• 

The ISP may be blocking network traffic on Port 80. Try changing the 

HTTP port to 2000 and re-configure the port forwarding 

• 

Refer to the Network Setup Section of the manual for more 

troubleshooting and for detailed instructions on how to set up the 

DVR for remote viewing  

• 

Make sure the batteries are installed correctly 

• 

Make sure you are pointing the remote at the IR sensor (on the top 

right side of DVR) 

• 

Point the IR Remote at the camera lens and press a button. You should 

be able to see the IR LED flicker through the DVR monitoring device

•          Try replacing the batteries in the remote

• 

Make sure the mouse is connected to the proper USB port. The proper 

port for the mouse is the top USB port on the back. It will be labelled 

with a mouse icon next to it

• 

There could be video loss, HDD loss, motion detection or no HDD space 

on your DVR. The CV301-8CH is set to alarm when those actions take 

place.  This is to alert you if anything is tampering with the camera 

to DVR connections the alarm will go off. Check your connections and 

keep the DVR in a safe place where it will not me tampered with or 

moved around

• 

Disconnect and reconnect all camera connections to make sure they 

are snug and tight fitting 

• 

Make sure the DVR is properly connected to the router. There should 

be green link indicator lights if the DVR is properly connected 

• 

Make sure the DVR IP Allocation is set to DHCP. This is a standard 

default setting that will work in most networking situations

• 

Power cycle the DVR is it is properly connected and the IP Allocation is 

set to DHCP

• 

This is completely normal. If the hard drive is playing back footage or 

recording, the light will blink to notify you that there is activity