Avaya 03-300430 用户手册

1018

ABRT

The test has been disabled by administration. The default for the Test field 
on the station screen is y. Determine why this field was set to n on this 
station. It may be due to the brief ringing disturbance that this test may 
cause.

1. To enable the test for the particular analog station being tested, enter 

change station extension and set the Test field on the station 

to y.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

FAIL

The terminal equipment is not connected to the circuit pack.  Some 
terminal equipment, such as modems, may fail even when connected 
properly.

1. Remotely test the equipment.

2. If the test fails again, look for RING-GEN errors in the Error Log.

3. Check all of the wiring between the station equipment and the switch.  

Then, run the test again.

4. If the test still fails, the set may be defective.  Check the set, and 

replace it, if necessary.

5. Some terminal equipment could fail even when it is connected 

properly. If this is the case, disable the test using change station 
extension (enter n into the Test field). Note that this action also 

disables Tests 6, 7, 161, and 35 on this port.

PASS

The station is connected properly to the switch.  This test may also pass if 

no terminal equipment is connected and the terminal is located very far 

from the switch.  Investigate user-reported troubles on this port by using 

other port tests or by examining the station and its wiring.

 2 of 3