Avaya 03-300430 用户手册

13

(cont’d)

MIN

2. From the Linux command line, enter start -a to restart the standby 

server.

3. Prevent any future misuse of the stop command.
4. Manually clear the alarm on the active server, either from the:

- Web interface, by selecting Alarms and Notification, the 

appropriate alarm, and Clear

- Linux command line, by entering almclear -n #id

Either the:

●

The alternate side is hung (ARB Event 8 is not being generated)

●

Two or more Interarbiter links are down (ARB Event 8 is also being 
generated)

Therefore, if the servers interchanged (the previously active server 

backed down to standby), use the following procedure:

5. Check for problems with an Ethernet interface, either from the:

- Web interface, by selecting the Execute Pingall diagnostic

- Linux command line, by entering pingall -a

Check both sides of each failed link, and make any necessary repairs.

a. If the Ethernet interfaces are OK, see if the standby server is 

busied-out, either from the:

- Web interface, by selecting View Summary Status

- Linux command line, by entering server

b. If so, release the standby server, either from the:

- Web interface, by selecting Release Server

- Linux command line, by entering server -r

If not, check for related alarms to troubleshoot the standby.

6. Manually clear the alarm, either from the:

- Web interface, by selecting Alarms and Notification, the 

appropriate alarm, and Clear

- Linux command line, by entering almclear -n #id

7. If the problem persists, escalate the problem.

 11 of 12