Baracoda RS232RS232 用户手册

Baracoda RS232 dongle Plug & Scan – User Guide v3.28.2

- 10 -

Data Capture

for Workforce

in Motion

How to connect your Baracoda barcode scanner

How to connect your BaracodaPencil/Pencil2

Reset your BaracodaPencil (see BaracodaPencil/Pencil2 User Guide to perform this operation).

Plug the dongle into the RS232 COM port of the computer and switch it on.

Do not scan any other barcodes except the ‘connect barcode’ that is delivered with the dongle.

The LED on the scanner will start double flashing green: you are now connected! (*)

Start scanning barcodes.

(*) If the LED on the BaracodaPencil is not double flashing green, this may possibly mean:

The BaracodaPencil is low on power. Charge the unit up completely and try again

The BaracodaPencil has not been reset. Reset it and try again

The BaracodaPencil has been programmed from its default status and it is not able to decode
the Code 128 symbology. Be aware that the pairing barcode is a code128 and so the
BaracodaPencil shall stay in its default mode “Code128

on”

By default, the Plug & Scan dongle activates the “No Data Loss Mode”. (Please refer to the paragraph 2.3
for additional information)

How to connect your BC2604/BL2604/BLR2604

Reset the scanner by taking out and replacing both batteries.

Plug the dongle into the RS232 COM port of the computer and switch it on.

Do not scan any other barcodes except the ‘connect barcode’ that is delivered with the dongle.

You will hear the scanner beeping for 7 times. After these 7 beeps, the LED on the scanner will start
double flashing green: you are now paired and connected! (**)

Start scanning barcodes.

(**) If the LED on the BL/BC/BLR2604 is not double flashing a green light, this may possibly mean:

•

The scanner is low on power. Charge the unit up completely and try again

•

The scanner has not been reset. Reset it and try again

•

The scanner has been programmed from its default status and it is not able to decode the
Code 128 symbology. Be aware that the pairing barcode is a code128 and so the scanner shall
stay in its default mode “Code128 on”