Paradox Hellas S.A. EVO48 用户手册

Depending on how your system is installed and on the type of keypad, there are various 
ways to enter and exit Access Control doors:

•

Present your Access Control card to the reader or the 
EVO641R or DGP2-641RB keypad. The system will 
verify that the card is allowed access according to its 
assigned Access Level and Schedule. If it is accepted, 
the system will unlock the door. The reader’s light can 
be programmed by the installer to turn green or 
extinguish briefly to indicate that the door can be 
opened.

•

When the motion detector detects movement (Request 
for Exit), it will unlock the door to permit passage from 
inside. 

•

Enter your user access code on the keypad and press 

.

•

If the Access Control door is on a “Door Unlocked 
Schedule”, you may be able to open Access Control 
doors without using a user access code or an Access Control card. Depending on the 
door’s programming, the door can remain unlocked during the entire programmed 
schedule or the door can unlock once a valid Access Control card is presented to the 
reader during the schedule and then will remain unlocked for the remainder of the 
schedule. 

•

presented to a door during its assigned Schedule (refer to step 8 in section 
7.5.1 on page 14).

•

presented to a door within its assigned Access Level (refer to step 8 in section 
7.5.1 on page 14).

•

programmed to allow arming (options 

 and

•

assigned to all areas that are assigned to the Access Control door (refer to step 
7 in section 7.5.1 on page 14), or assigned to at least one of the areas assigned 
to the Access Control door depending on how your installer has programmed 
the Access Control door.

To disarm and unlock an Access Control door when the area assigned to it is 
armed, present your Access Control card to the reader or EVO641R / DGP2-
641RB keypad (door). The Access Control card must be:

•

presented to a door during its assigned Schedule (refer to step 8 in section 
7.5.1 on page 14).

•

presented to a door within its assigned Access Level (refer to step 8 in section 
7.5.1 on page 14).

•

programmed to allow disarming (option [2] in section 7.7 on page 15).

•

assigned to all areas that are assigned to the Access Control door (refer to step 
7 in section 7.5.1 on page 14), or assigned to at least one of the areas assigned 
to the Access Control door depending on how your installer has programmed 
the Access Control door.