Monte Carlo Fan Company 5ROR 用户手册

Lift Canopy to ceiling aligning the key hole slots

with the screws on the bottom of the Mounting

bracket.  Rotate the canopy Counter Clockwise

to lock in place.  Tighten the screws to secure

the Canopy.  See inset for Keyhole shape

Attach blades to blade arms with

screws and washers supplied. Repeat

for all 5 blades.

Re-install safety bar removed in step

3 by placing safety bar on screws,

sliding into place, and tightening the

2 screws.

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wire nut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more

than one fan with remote.  You can set the dip switches to

different positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Place canopy over downrod.

Place upper housing over downrod.

Install ball on downrod, replace cross

pin and tighen screw securely.

Hang assembled fan from the mounting brack-

et installed to ceiling in previous step.  Make

sure the fan is hanging straight.  Rotate fan

until the tab on the Mounting bracket engages

the slot on the Downrod Ball.  This must be

done to prevent the fan body from rotating

when the blades are in motion.

Fan and light kit combinations over 70 lbs,

in both flush and downrod mode the safety

cable must be installed into the house struc-

ture beams using the 3” lag screws,washers,

and lock washers. provided.  Make sure that

when the safety cable is fully extended the

lead wires are longer than the cable and no

stress is placed on the lead wires. 

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer

Install remote receiver by sliding into

opening in the Mounting bracket.  Make

sure that the dip switches on the

Transmitter and the Receiver are set to

the same position.  

white

black

Make wiring connections as indicated above.

White from fan to white from remote marked

N. Orange from fan to Orange from remote

marked Light/up. Blue from fan to blue from

remote marked down light. Black from fan to

Black from remote marked L. White from

house to white from remote marked AC N .

Black from house to Black from remote

marked AC L. Connect all green ground wires

to Ground wire from House.

orange

blue

Green

white

black

House

Fan

fuses