Weber Built In LP Side Burner 用户手册
14
SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should be
in the OFF position.
in the OFF position.
Make sure wire is connected between the igniter and electrode. Spark should
be a white/blue color, not yellow.
be a white/blue color, not yellow.
1) Igniter
Wire
2) Burner
(3)
Side Burner Grate
Side Burner Cap
Side Burner Ring & Head
Igniter Electrode
Control Knob
Igniter
SIDE BURNER TROUBLESHOOTING
PROBLEM
CHECK
CURE
Side Burner does not light.
Is gas supply off?
The excess fl ow safety device, which
is part of the barbecue to cylinder
connection, may have activated.
is part of the barbecue to cylinder
connection, may have activated.
Turn supply on.
To reset the excess fl ow safety device turn all burner control knobs and
the cylinder valve OFF. Disconnect the regulator from the cylinder. Turn
burner control knobs to HIGH. Wait at least 1 minute. Turn burner control
knobs OFF. Reconnect the regulator to the cylinder. Turn cylinder valve
on slowly. Refer to “Lighting Instructions”.
the cylinder valve OFF. Disconnect the regulator from the cylinder. Turn
burner control knobs to HIGH. Wait at least 1 minute. Turn burner control
knobs OFF. Reconnect the regulator to the cylinder. Turn cylinder valve
on slowly. Refer to “Lighting Instructions”.
Flame is low in HIGH position
Is the fuel hose bent or kinked?
Straighten hose.
Push button ignition does not
work.
work.
Does burner light with a match?
If match lights burner, check igniter (see below).
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact
information on our web site. Log onto www.weber.com
information on our web site. Log onto www.weber.com
®
.