Chamberlain RWA310R 用户手册
Carton Inventory
Overview
The Alert uses a Passive Infra-Red sensor to detect
movement of people and vehicles, while allowing
small animals to pass through undetected.
movement of people and vehicles, while allowing
small animals to pass through undetected.
PIR Motion Sensor Assembly
& Test
& Test
Step 1
Attach PIR Motion Sensor box to mounting plate with
large silver screw. Tighten screw until PIR Motion
Sensor stays in place when repositioned.
large silver screw. Tighten screw until PIR Motion
Sensor stays in place when repositioned.
Model RWA310R
Wireless Pedestrian & Vehicle Alert
Base Station
Passive Infra-Red (PIR)
Motion Sensor
1
Swivel Bushing
Mounting Plate
AC Adapter
Rubber Pads
Sun/Rain Shield
®
Operation & Features
Relay Output
Contacts
Contacts
AC Adapter
Base Station Switch #1
Base Station Switch #2
Base Station Switch #2
Learn Button
Antenna
Mute/Off
Button
Button
Base Station
Base Station Switches:
Switch #1:
Switch #1:
Switch #2:
Programming Additional PIR Motion Sensors: The
Base Station can learn the code of up to 3 additional
PIR Motion Sensors, responding with unique buzzes.
To program additional PIR Motion Sensors see Step 6.
Base Station can learn the code of up to 3 additional
PIR Motion Sensors, responding with unique buzzes.
To program additional PIR Motion Sensors see Step 6.
Clear Memory: Press and hold the Learn Button on
the Base Station until 3 beeps are heard.
the Base Station until 3 beeps are heard.
On/Off: To turn Base Station off hold down the Mute
Button until it powers down. The Base Station can be
turned on by pressing the Mute Button.
Button until it powers down. The Base Station can be
turned on by pressing the Mute Button.
Mute: Press and release the Mute Button to put the
Base Station into Sleep Mode for one hour. After an
hour it will activate automatically.
Base Station into Sleep Mode for one hour. After an
hour it will activate automatically.
Battery: The AA Alkaline batteries (not provided) in
the PIR Motion Sensor will last up to 2 years
depending on use (Lithium batteries recommended
for colder environments). If Base Station battery
(optional) is low, it will beep every few minutes.
Replace with 9-Volt battery (not provided). For peak
performance inspect batteries annually and replace
as needed.
the PIR Motion Sensor will last up to 2 years
depending on use (Lithium batteries recommended
for colder environments). If Base Station battery
(optional) is low, it will beep every few minutes.
Replace with 9-Volt battery (not provided). For peak
performance inspect batteries annually and replace
as needed.
1
2
ON
OFF
Step 2
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Test light will flash.
batteries recommended for colder environments.)
Test light will flash.
OFF Buzzer
Off
ON
Buzzer On (Default)
OFF Long
Buzz
ON
Short Buzz (Default)