Hitachi NT50AGF 用户手册

— 14 —

1. Power Source

V

  Use only clean, dry, regulated compressed air as a power source 

for this Nailer

V

  Air compressors used to supply compressed air to this Nailer 

must comply with the requirements of the latest version of ANSI 

Standard B 19.3 “Safety Standard For Compressors For Process 

Industries.”

V

  Moisture or oil in the air compressor may accelerate wear and 

corrosion in the Nailer.

V

  Drain daily.

V

  Air volume is as important as air pressure. Both should be con-

sidered when choosing a compressor to use with this tool. The 

air volume supplied to the tool may be inadequate because of 

undersized fittings and hoses or from the effects of dirt and wa-

ter in the system. Inadequate or restricted air flow will prevent 

the tool from receiving an adequate volume of air, even though 

the pressure reading is high. Compressors with lower CFM rat-

ings may experience inadequate air flow while the compressor 

is running. Low volume or pressure may result in slow opera-

tion, jamming, miss-feeds or reduced driving power.

V

  Air Compressor:

  Minimum Air Compressor Requirements

 • HP: 1 1/2 HP or greater.

 • Compressor Rated at 135 PSI Max. or greater.

 • Accumulator Tank Capacity: 4 Gallons or greater

 • Pressure Regulator: Set operating pressure at 90 - 110 PSI.

 • SCFM @ 90 PSI: 3.5 CFM

 • Pressure Switch Trip On: 110 PSI (± 5)

 • Pressure Switch Trip Off: 135 PSI (± 5)