GE ADEH50 用户手册

下载
页码 36
NOTE:  When the bucket is full or removed, the 
controls cannot be set.
   Power Pad
  Press to turn the dehumidifier on and off.
  
Filter Timer
  After 250 hours of operation, the Clean the Filter 
indicator light will glow to remind you to clean 
the filter. Remove the filter and clean it. 
  Press to turn off the Clean the Filter light. See 
the Care and Cleaning section.
 
  
Humidity Set Control Pads
  The humidity level can be set within a range of 
35% RH (Relative Humidity) to 80% RH (Relative 
Humidity) in 5% increments or at CO for 
continuous operation.  To set the unit for 
continuous operation, press the 
▼ pad until 
the screen reads CO.
  NOTE:  If CO (Continuous) is selected, the 
dehumidifier will operate continuously at  
its maximum dehumidification settings if 
attached to a hose to drain or until the bucket 
is full.
  For drier air, press the 
▼ pad and set to 
a lower percent value (%).
  For damper air, press the 
▲ pad and set 
to a higher percent value (%).
  
When you first use the dehumidifier, set 
the humidity control to 45% or 50%. Allow at 
least 24 hours for the dehumidifier to achieve 
the humidity level. If you still have damper air 
than desired, set the humidity level to a lower 
setting or select Continuous for maximum 
dehumidification.
  Display
  Shows the set % humidity level while setting, 
then shows the actual (+/– 5% accuracy) 
room % humidity level.
Fan Speed Pad
 Controls the fan speed.
  Press to select either HighMedium or Low fan 
speed.
  Set the fan control to High for maximum 
moisture removal. When the humidity  
has been reduced and quiet operation is 
preferred, set the fan control to Medium 
or Low.
  Delay Off
  While the dehumidifier is in operation, press 
this pad to set it to automatically turn off in 2 
hours or 4 hours.
4
Consumer Support
Troubleshooting Tips
Operating Instructions
Safety Instructions
Troubleshooting Tips
Care and Cleaning
Safety Instructions
Operating Instructions
Clean the Filter 
indicator light
About the controls on the dehumidifier.
Controls
Other Features
BUCKET FULL Light
Glows when the bucket is ready to be emptied, or 
when the bucket is removed or not replaced in the 
proper position.
Alarm
If the bucket is full or missing for more than 3 
minutes, an alarm will sound for about 10 seconds 
to remind you to empty and replace the bucket.
Auto Shut Off
The Water Level Control Switch shuts off the 
dehumidifier when the bucket is full, or when 
the bucket is removed or not replaced in the 
proper position.  NOTE:  Fan will continue to run 
approximately 3 minutes after bucket is removed.
Auto Defrost
When frost builds up on the evaporator coils, the 
compressor will cycle off and the fan will continue 
to run until the frost disappears.
Power Outage
In the case of a power outage or interruption, the 
unit will automatically restart, in the settings last 
used, after the power is restored.
Continuous operation on 
indicator light
Bucket Full light indicates 
bucket needs to be emptied  
or is not in place in the unit
4 hour or 2 hour  
delay off  
indicator lights 
High, Medium 
and Low fan 
indicator lights
Power On 
indicator light