Wayne-Dalton 9100 用户手册

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your 

local yellow pages/business listings or go to the 

Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

Make one mark 1” (25 mm) up from 
the center of bottom edge of the bottom 
section and another mark 2-3/16” (56 mm) 
up from the first mark. 

Drill a 7/16” (11 mm) hole through the 
section at each mark and insert the outside 
step plate. 
 
Loosely fasten step plate slide to base with 
(1) 1/4” - 20 x 5/8” carriage bolt and nut. 

Align inside step plate holes and fasten 
from inside using the #8 screws provided. 
Install one #8 x 3/4” screw in the bottom 
step plate hole. The screw in the top hole 
varies with door models. 

Use the screw size shown below for your 
model door.

a) #8 x 3/4” screw for Model 9100
b) #8 x 1” screw Model 9600/9400

Tighten 1/4”-20-5/8” carriage bolt and 
nut.

STEP PLATE OUTSIDE

STEP PLATE INSIDE

7/16” Drill bit

Power Drill

#8 SCREWS

ASSEMbLED 

STEP PLATE

1/4” - 20 X 5/8” 
CARRIAGE bOLT

HEX NUT

STEP PLATE 

bASE

STEP PLATE 

SLIDE

2-3/16”

1”