Emerson Process Management 3400 用户手册

3-9000-743 Rev S

June 2013

You may need to adjust your Meter Directory settings for the connection so that they match the 
port default settings. For Windows® 2000 or XP there could be multiple drivers installed called 
Communications cable between two computers, one for each COM port on the machine. For 
Windows Vista™ you can not use the Communication cable between two computers at this 
time and must use the Daniel Direct Connection driver.
Port A will default to 9600 baud and Port B will default to 19200 baud. Both ports will have an 
address of 32.

4.

For Ethernet Connections: If you are connecting to the meter over an Ethernet port, you 

should be able to connect with the same IP address as normal.  If this is unsuccessful, 
the meter may have defaulted to 192.168.135.100 with a subnet of 255.255.255.0.  
Make sure your PC has a compatible address and attempt a connection using this IP 
address. 

5.

Once your cabling and Meter Directory record are setup, attempt the connection to the 

meter.  You will receive a message 

. 

•

Click the 

 button and you will be prompted to 

•

Click the 

 button and if successful, Daniel MeterLink displays the message, 

6.

Next, use the 

 pull down menu and select 

to re-start the 

firmware upgrade process.
If the firmware upgrade is successful and the meter’s configuration is not lost, the 
meter should start working correctly. 
If the meter configuration is lost, use the Edit/Compare Configuration screen to write 
the configuration file, saved by the Program Download utility on the initial firmware 
upgrade, to the meter.
If the firmware upgrade fails again, please contact Daniel Technical Support for 
assistance. Contact information can be found in Daniel MeterLink from the Help pull 
down menu and selecting Technical Support.