Vermont Casting TBREF36 用户手册

9

1.  Remove the plastic bag from each screen.
2.  Remove the four (4) metal clips, two (2) for each 

side of the fireplace opening.

3.  Slide screen panels against sides of the fireplace 

opening.

4.  Align each metal clip with the hole it was removed 

from, while at the same time, hooking the clip 
through the last wire of the screen. Snap clips into 
place. (Fig. 5)

5.  Pull screens back and forth to ensure they work 

freely.

Fp1041

screen install

3/30/00   djt

(Clip)

Fig. 5  Clip installation.

FP1041

The motors used on the fan and the drum assemblies 

are prelubricated for extended bearing life, and require 

no further lubrication.  However, periodic cleaning/vacu-

uming of the fan/ heater is recommended.

This fireplace uses four (4) clear, 120 Volt, 60 Watt,  

E-12 socket base (small base, chandelier candle-type) 

light bulbs. These lights are located under the ember 

bed of the unit. 

them burns out.
1.  Turn OFF the power to the unit at the main service 

panel.

2.  If the fireplace has been operating, allow it to cool.
3.  Open glass (if applicable); open steel curtain.

4.  Remove the four (4) screws securing the ember bed 

in position. Two (2) screws are located on either side 
of the ember bed near the front and rear.

5.  Examine the bulbs to determine which one(s) need 

to be replaced (if you are not going to replace all).

7.  Install new light bulb(s) by screwing in while holding 

the socket.

8.  Reinstall the ember bed, log set, glass door, and 

steel curtain.

Clean the trim using a soft cloth you have slightly damp-

ened with lemon oil; then buff with a clean soft cloth.
NOTE: You can obtain lemon oil at super-markets