New Buck Corporation DV23ZC 用户手册
LOG INSTALLATION
1. You must first unfold the left and right log support tabs.
These tabs are folded down for shipping and must be
unfolded before the rear log is put into place.
unfolded before the rear log is put into place.
2. Place the rear log #1 on the back side of the burner base,
flat side toward the rear of the firebox.
3. Take the middle log #2, Grasp it by both ends with
ember burn out facing you. Position it between the front
and rear burner in the middle of the burner supports.
and rear burner in the middle of the burner supports.
4. Center the front log #3 between the middle log and the
front of the burner base.
5. Place the top right log #4 over the pin in the middle log
with the branch end resting in the notch of the rear log
toward the rear of the unit.
toward the rear of the unit.
6. 5. Place the left top log #5 in the notch on the top left of
rear log and the other end in the notch on top left of the
middle log.
middle log.
7. You may spread the lava rock (provided with unit) over
the rest of the inner bottom.
NOTE: IF NECESSARY YOU MAY ADJUST THE REAR
TOP LOGS TO THE LEFT OR RIGHT TO ENSURE THE
FLAME IS NOT IMPINGING ON THE LOGS.
8. Light the pilot and cycle main burner to ensure that the
flame smoothly ignites each burner. It may also be
necessary to install logs and glass before the final pilot
lighting.
necessary to install logs and glass before the final pilot
lighting.
NOTE: LOGS MAY PRODUCE STRONG ODOR ON
INITIAL CONTACT WITH FLAME. THIS WILL
DISSIPATE AFTER APPROXIMATELY ONE HOUR OF
CONTINUOUS BURNING.
Figure 18
5
4
1
2
3
Tabs shown unfolded
22