Regency B36X 用户手册

Regency Bellavista™ B36X Gas Fireplace

INSTALLATION

18)

Verify that if the conversion is from NG to LPG, the screw must

be re-assembled with the red o-ring visible (Fig. 5).

19)

Re-assemble the black protection cap (Fig. 6).

LPG Configuration

Red o-ring visible

Fig.5

20)

Reverse steps 8 - 1.

21)

Attach the label "This unit has been converted to LPG" near or on
top of the serial # decal.

Fig. 6

WARNING!

Also check that the pilot and main

burner injectors are appropriate for

the gas type.

22)

Replace yellow "NG" label with red "LPG" label.

Fig. 1

Fig.2

Fig.4

Fig.3

17)

Using the Allen wrench as shown in

Fig.4, rotate the screw clockwise until
snug, do not overtighten.

14)

Insert a 5/32” or 4mm Allen wrench into the hexagonal key-way

of the screw (Fig. 2), rotate it counter-clockwise until it is free and
extract it.

15)

Check that the screw is clean and if necessary remove dirt.

16)

Flip the screw (Fig. 3).

WARNING!

Do not over tighten the screw.

Recommended to

grip the wrench by the short side.

12)

Turn control knob to the “OFF” position.

13)

Remove the black protection cap by hand from the hi-low knob

(Fig.1).

Cap

Red O-ring