PGS TC36 AR 用户手册
050505-36
36ARB2 19
VENT RESTRICTOR ADJUSTMENT
The vent restrictor is located on the underside of the fi rebox
top. The unit leaves the factory with the vent restrictor wide
open. The restrictor is built into the appliance for secondary
air fl ow adjustment. Adjustment enables tuning the airfl ow
for optimum fl ame appearance and performance for a wide
variety of vent confi gurations.
top. The unit leaves the factory with the vent restrictor wide
open. The restrictor is built into the appliance for secondary
air fl ow adjustment. Adjustment enables tuning the airfl ow
for optimum fl ame appearance and performance for a wide
variety of vent confi gurations.
Setting:
- determine the vent height
- determine the vent horizontal length
- from the chart determine the restrictor position
Refer to the chart in Fig. 26 for the correct position of restrictor
for the vent confi guration of your installation. Restrictor posi-
tions are based upon lab tests. The ideal position may vary
slightly with installation.
- determine the vent height
- determine the vent horizontal length
- from the chart determine the restrictor position
Refer to the chart in Fig. 26 for the correct position of restrictor
for the vent confi guration of your installation. Restrictor posi-
tions are based upon lab tests. The ideal position may vary
slightly with installation.
Restrictor position is too closed if the fl ame has the following
characteristics:
- Flame is excessively tall and lifting.
- Flame
characteristics:
- Flame is excessively tall and lifting.
- Flame
lacks
movement.
- Flame
soots.
Restrictor position is too open if the fl ame has the following
characteristics:
- Flame height is low.
- Flame has excessive movement.
characteristics:
- Flame height is low.
- Flame has excessive movement.
To adjust the restrictor:
- Loosen the screw holding the restrictor.
- Push the restrictor back to its intended opening.
- Tighten
- Loosen the screw holding the restrictor.
- Push the restrictor back to its intended opening.
- Tighten
the
screw
MANUFACTURED (MOBILE) HOME
In some jurisdictions, the Town & Country Fireplace may
be installed in Manufactured Homes after the "fi rst sale".
be installed in Manufactured Homes after the "fi rst sale".
Consult local codes for approval. The fi replace must be
fastened in place.
fastened in place.
Install in accordance with the current standard Mobile Homes,
CAN/CSA Z240 MH (in CANADA), and the Manufacturer's
Home Construction and Safety Standard, Title 24 CFR,
Part 3280 or the current Standard for Fire Safety Criteria for
Manufactured Home Installations, Sites and Communities
ANSI/NFPA 501A (in the U.S.A.).
CAN/CSA Z240 MH (in CANADA), and the Manufacturer's
Home Construction and Safety Standard, Title 24 CFR,
Part 3280 or the current Standard for Fire Safety Criteria for
Manufactured Home Installations, Sites and Communities
ANSI/NFPA 501A (in the U.S.A.).
WALL AND ROOF
TERMINATION
RESTRICTOR
POSITION
VENT RESTRICTOR
Fig. # 26
Fig. # 25
OPENING
12'
10'
30'
40'
48'
6'
4'
2'
0'
8'
30'
18"
4'
20'
22'
18'
20'
FULLY OPEN
3" OPEN
2" OPEN
3/4" OPEN LP
10'
0'
1" OPEN NG
6'
8'
10'
12'
14'
16'
18'
20'