Enviro 50-927 用户手册

Secondary Installation

Figure 39: Once the logs are in

place the embers can be placed

onto and around the burner to

create a realistic look. Bags of

ceramic fiber embers and rock

wool are provided. The ceramic

fiber comes in chunks that are

about 2 inches (5.1 cm) long.

Place them irregularly around

the burner. When there is a

sparse but even layer of embers,

spread the rock wool in the

same manner.

Figure 39. Complete log set-up with embers.

WARNINGS: DO NOT pack this ember material as this could create an unsafe condition. The pieces

should be lightly placed so they don’t block any of the burner ports. DO NOT allow any of the embers to

rest against the pilot assembly.
Caution: Use only the type of ember material supplied with this fireplace. Due to the irregular size of

the ember material, there may be more than required. Use of other foreign materials on the burners may

create dangerous conditions.

Figure 40. DV36 complete log set-up with embers burning.

it to cool down. Then remove the glass and rearrange the ember material, making sure none of the

burner ports are blocked.
Maintenance: Once a year, the logs should be removed and checked for deterioration or large amounts

of soot. A small amount on the bottom side of the logs is normal. Remove and replace the logs in the

same manner described above.
If new/more embers and rock wool are required, contact your nearest ENVIRO dealer.
Never operate the fireplace with the glass door removed.

Figure 40: The DV36

burning with a good

flame.
NOTE: While the glass

is still removed, it is

recommended that the

gas line be purged by

lighting the pilot.
When

lighting

the

fireplace for the first

time since the log set

and embers have been

installed/replaced, watch

for ignition at ALL the

burner ports. If a long

delay is noticed, turn the

appliance off and wait for