Enviro ENVIRO 用户手册
Figure 58. Ceramic Liner Support.
Secondary Installation
Figure 57. Retreat complete log set-up with embers burning.
Never operate the fireplace with the glass door removed.
I
NSTALLATION
OF
C
ERAMIC
F
IREBOX
L
INER
:
IMPORTANT: A CERAMIC LINER MUST BE INSTALLED BEFORE UNIT IS LIT!
Figure 57 shows The Retreat burning with a
good flame.
NOTE: While the glass is still removed, it is
NOTE: While the glass is still removed, it is
recommended that the gas line be purged by
lighting the pilot.
When lighting the fireplace for the first time
When lighting the fireplace for the first time
since the log set and embers have been
installed/replaced, watch for ignition at ALL
the burner ports. If a long delay is noticed,
turn the appliance off and wait for it to cool
down. Then remove the glass and rearrange
the ember material, ensuring none of the
burner ports are densely blocked.
Maintenance: Once a year, the charcoal
Maintenance: Once a year, the charcoal
pieces and logs should be removed and
checked for deterioration or large amounts of
soot. A small amount on the bottom side of
the logs is normal. Remove and replace the
logs in the same manner described above.
If new/more rock wool embers are required,
If new/more rock wool embers are required,
contact your nearest ENVIRO dealer.
Turn off the gas control knob and allow the
unit to cool.
NOTE: The ceramic liner is fragile and
NOTE: The ceramic liner is fragile and
should be handled gently. Please ensure that
it has not been damaged.
To install the liner:
1. Remove the glass door by following the
To install the liner:
1. Remove the glass door by following the
instruction in the “S
ECONDARY
I
NSTALLATION
- G
LASS
D
OOR
R
EMOVAL
” section and remove
logs if necessary.
2. A ceramic liner support must be in place
around burner (shown with a white outline in
Figure 58).
34