Roberts Gorden TF-120 用户手册
TF-S
ERIES
I
NSTALLATION
, O
PERATION
AND
S
ERVICE
M
ANUAL
8
SECTION 5: MAJOR COMPONENTS
FIGURE 11: Major Component Descriptions
Burner with Tube Gasket
Must be installed with the
flame observation
window facing down.
Reflector
(Aluminum or
Stainless
Steel)
Alternate overlap as
shown on overview and
on Page 16, Figure 14.
Minimum overlap is 6" (16 cm).
(Aluminum or
Stainless
Steel)
Alternate overlap as
shown on overview and
on Page 16, Figure 14.
Minimum overlap is 6" (16 cm).
Tube and Reflector Hanger
with Clamp Package
Position this hanger no more
than 4" (10 cm) away from the
burner.
with Clamp Package
Position this hanger no more
than 4" (10 cm) away from the
burner.
Coupling Assembly
with Lock
with Lock
Reflector End Cap
Punch out center
section to
accommodate tube.
Punch out center
section to
accommodate tube.
Tube and Reflector Hanger
Suspend system from these
hangers.
Suspend system from these
hangers.
Flex Gas Line with
Shut Off Cock
Shut Off Cock
Tube
Hot Rolled or Heat
Treated Aluminized Tube
Supplied in 10' (3 m) lengths.
Hot Rolled or Heat
Treated Aluminized Tube
Supplied in 10' (3 m) lengths.
Burner Tube
Supplied in 10
Supplied in 10
'
(3 m) lengths. Burner
tube is always the first tube
after the burner.
tube is always the first tube
after the burner.
Reflector Support Strap &
Wire Form
Wire Form
Turbulator
Turbulator must be
installed in the last standard
section of tube. Turbulator is
not required on the TF-250/
300/350/380. For installation
see Page 21, Section 7.5.
Turbulator must be
installed in the last standard
section of tube. Turbulator is
not required on the TF-250/
300/350/380. For installation
see Page 21, Section 7.5.
Flexible Boot
Flexible boot is used to
connect the last tube to
the vent.
Flexible boot is used to
connect the last tube to
the vent.
Vent Sleeve
Vent Sleeve installed
inside flexible boot.
Vent Sleeve installed
inside flexible boot.