dreamGEAR P186 用户手册
Page 4
UNPACKING:
1. Remove heater from carton.
2. Remove all protective packaging applied to heater for shipment.
3. Check heater for any shipping damage. If heater is damaged,
2. Remove all protective packaging applied to heater for shipment.
3. Check heater for any shipping damage. If heater is damaged,
promptly inform dealer/distributor where you bought heater.
PRODUCT FEATURES:
Safety Device
This heater has a pilot with an Oxygen Depletion Sensor Shutoff System
(ODS).
The ODS pilot is a required feature for vent-free room heaters. The
ODS pilot shuts off the heater if the normal air oxygen content is reduced
to 18%.
(ODS).
The ODS pilot is a required feature for vent-free room heaters. The
ODS pilot shuts off the heater if the normal air oxygen content is reduced
to 18%.
Piezo Ignition System
This heater has a piezo ignitor. This system requires no matches,
batteries, or other sources to light heater.
batteries, or other sources to light heater.
Thermostatic Heat Control
Thermostat has a sensing bulb, and a control valve. This results in the
greatest heater comfort. This can also result in lower gas bills.
greatest heater comfort. This can also result in lower gas bills.
FRESH AIR FOR COMBUSTION AND VENTILATION:
WARNING : This heater must have fresh air for proper operation. If not, poor
fuel combustion could result. Read the following instructions to insure proper fresh
air for this and other fuel-burning appliances in your home.
fuel combustion could result. Read the following instructions to insure proper fresh
air for this and other fuel-burning appliances in your home.
ADEQUATE COMBUSTION/VENTILATION AIR
All spaces in homes fall into one of the three following ventilation classifications:
Unusually Tight Construction : The air that leaks around doors and windows
may provide enough fresh air for combustion and ventilation. However, in
buildings of unusually tight construction, you must provide additional fresh air.
Unusually Tight Construction is defined as construction where:
-Walls and ceilings exposed to the outside atmosphere have a continuous
water vapor retarder with a rating or one perm or less with openings gasketed or
sealed and
-Weather stripping has been added on openable windows and doors
-Caulking or sealants are applied to areas such as joints around window and
door frames, between sole plates and floors, between wall-ceiling joints,
between wall panels, at penetrations for plumbing, electrical and gas lines, and
at other openings.
buildings of unusually tight construction, you must provide additional fresh air.
Unusually Tight Construction is defined as construction where:
-Walls and ceilings exposed to the outside atmosphere have a continuous
water vapor retarder with a rating or one perm or less with openings gasketed or
sealed and
-Weather stripping has been added on openable windows and doors
-Caulking or sealants are applied to areas such as joints around window and
door frames, between sole plates and floors, between wall-ceiling joints,
between wall panels, at penetrations for plumbing, electrical and gas lines, and
at other openings.