Keating Of Chicago 055173 产品宣传页

www.keatingofchicago.com

1-800-KEATING

HardPiping057122.qxd

Page 1 of 2

Operation #1 Dis-Assembly

1. Drain and clean all oil from filter tub assembly. Remove filter tub assembly 

from filter cart frame assembly. This assembly will be turned over (upside 
down), for replacement of parts and adjustment to mating part on motor 
mount housing assembly.

2. Remove pull rod and set aside; this part will be used later.

3. Loosen compression fitting at pump output. Do not remove 90° 

fitting from pump.

4. Remove (4) bolts holding bracket SE coupler. This assembly will be 

replaced with new parts in kit. The bracket and flex tubing with quick 
connect are to be discarded.

5. Inspect 90° compression fitting on the pump as shown in View A – A. If the 

fitting is not on center line of the radius on the pump mount housing 
assembly as shown, use a #23 or #24 drill to remove pump housing 
covers (2) as shown in view A – A, to gain easier access to the top bolts 
holding the motor/pump. Loosen (4) bolts on motor/pump to center 90° 
fitting as best as possible. These covers will be re-assembled with parts 
in the kit. After adjustments are made to the motor/pump to center 90º 
compression fitting as shown in view A – A, tighten the (4) bolts for the 
motor/pump.

Motor/Pump

Housing Covers

See Note #5

(2X)

Motor/Pump

Housing Assembly

90° Compression
Fitting See Notes

#3 and #5

Pull Rod 

See Note #2 Compression Fitting

See Note #3

Bracket SE Coupler
See Note #4

Filter Cart Frame Assembly

Filter Tub Assembly 
See Note #1

Use these Service
Instructions for the
following Kit part #’s:

Caution:
Make Sure Saftey Glasses are Worn