Premier PHP HWC-260 用户手册

Premier Heat Pumps – Water Heater and Chiller Manual 

Page 5

 

Do not climb on the unit or try to move 
it once installed. 

Keep out of reach of children. Do not 
allow them to play on or near the unit. 

Do not place foreign objects or fingers 
into the air inlet/outlet. The fan runs at 
high speed and can cause serious 
injury. Do not operate the unit without 
the safety grill in place. 

Important: Ensure that the plug remains 
clean, free from moisture, foreign objects 
and dirt. Ensure that the plug is properly 
inserted or hard wired by a qualified 
electrician. 

If the unit operates abnormally, stop 
the unit by firstly switching it off and 
then unplug the unit. For example, if 
there is a strange smell or abnormal 
noise coming from the unit. 

Do not clean the appliance with water. 
Water will go into the unit and will destroy 
the insulation. 

Turn the unit off at the wall before 
unplugging the unit. Do not disconnect 
the power while the unit is running. 

Do not pull on the cable to unplug the 
unit, damage to the plug and cable could 
occur 

Do not touch the plug with wet hands, 
as electric shock can occur. 

Ensure that the power to the heat pump is 
disconnected before removing leaves, 
particles or other foreign objects from the 
air inlet vanes. 

 

Verify the network specifications, with the unit data recorded on the heat pump 
prior to installation. 

Any additional disinfectant systems, such as chemical or electrolysis are not 
recommended for use with this hot water heat pump. The pump MUST be installed 
prior to these systems. 

For optimal operation of the heat pump, the following maximum values apply: 
A. Use of free chlorine : max : 2.6mg/l 
B. Total bromine : max : 5.6mg/l 
C. pH : between 6.5 and 8.0