Mitsubishi Electronics MS24WN 用户手册

25

For service, set time can be shortened by short circuit of JPG and JPS the electronic control P.C. board.
The time will be shortened as follows. (Refer to page 37.)

Set time : 1 minute 

➔ 

1-second

Set time : 3 minute 

➔ 

3-second (It takes 3 minutes for the compressor to start operation. However, the starting time is 

shortened by short circuit of JPG and JPS.)

A maximum of 4 indoor units with wireless remote controllers can be used in a room.
In this case, to operate each indoor unit individually by each remote controller, P.C. boards of remote controller must
be modified according to the indoor unit number.
How to modify the remote controller P.C. board
Remove batteries before modification.
The board has a print as shown below :

NOTE : For remodelling, take out the batteries

and press the 
OPERATE/STOP(ON/OFF)button
twice or 3 times at first.
After finish remodelling, put back the
batteries then press the RESET
button.

The P.C. board has the print “J1” and “J2”. Solder “J1” and “J2” according to the number of indoor unit as shown in Table 1.
After modification, press the RESET button.

How to set the remote controller exclusively for particular indoor unit
After you turn the breaker ON, the first remote controller that sends the signal to the indoor unit will be regarded as the
remote controller for the indoor unit.
The indoor unit will only accepts the signal from the remote controller that has been assigned to the indoor unit once
they are set.
The setting will be cancelled if the breaker has turned off, or the power supply has shut down.
Please conduct the above setting once again after the power has restored.

No. 1 unit

No. 2 unit

No. 3 unit

No. 4 unit

1 unit operation

No modification

–

–

–

2 units operation

Same as at left

Solder J1

–

–

3 units operation

Same as at left

Same as at left

Solder J2

–

4 units operation

Same as at left

Same as at left

Same as at left

Solder both J1 and J2

OB311--1.qxp  04.1.13 9:53 AM  Page 25