Haier HTWR12XCK 用户手册
Fig.B
Mounting tabs can be bent or cut off if not needed.Please use
the correct holes to match the sleeve.
the correct holes to match the sleeve.
Fig.C
On 26
3/4
”-27” sleeves:Use existing rear grille and redirect
louvers
to 60 angle as shown in Fig.C
to 60 angle as shown in Fig.C
5
5.If the depth of your existing wall sleeve is less than or equal
WR´VNLSWRVWHS2WKHUZLVHFXWWKHEDIÀHVDQGWKHVXSSRUW
blocks according to length“A” in the table below.
WR´VNLSWRVWHS2WKHUZLVHFXWWKHEDIÀHVDQGWKHVXSSRUW
blocks according to length“A” in the table below.
6.Remove the backing from the support blocks and attach
them to the inside of the wall sleeve as shown FIG E.Slide the
EDIÀHLQWRVROWVRIWKHVXSSRUWEORFNV
them to the inside of the wall sleeve as shown FIG E.Slide the
EDIÀHLQWRVROWVRIWKHVXSSRUWEORFNV
8.Install the 1”x1
1/2
”x84”long stuffer seal between the wall
sleeve and the unit.
9.To assemble trim,snap the tab of each piece into the slot of
the other piece as shown below.2-Trim frames are supplied
ZLWKXQLWXVHWKHWULPIUDPHWKDWEHVW¿WV\RXUVOHHYH
6OLGHWULPRYHUWKHIURQWRIWKHDLUFRQGLWLRQHUXQWLOWULPLVÀXVK
with sleeve as shown below.
9.To assemble trim,snap the tab of each piece into the slot of
the other piece as shown below.2-Trim frames are supplied
ZLWKXQLWXVHWKHWULPIUDPHWKDWEHVW¿WV\RXUVOHHYH
6OLGHWULPRYHUWKHIURQWRIWKHDLUFRQGLWLRQHUXQWLOWULPLVÀXVK
with sleeve as shown below.
Note:Be sure to route the cord through the trim frame before
placing the trim frame on the unit.
placing the trim frame on the unit.
7.Install the new unit into the wall sleeve.
Depth“D” of the
existing wall
sleeve(inches)
existing wall
sleeve(inches)
Length“A”
（inches）
（inches）
20<D<20
20 <D<21
21 <D<24
1-
4
5
8
3
4
3
4
5
8
3
4
3
4
A
A
Fig.D
Tapered Spacer
Block Board
Block Board
FRONT
Wall
Sleeve
Sleeve
Wall
Fig.E
Tapered Spacer
Block
Block
6
1
2
”
Assemble Trim
Fig.F