Haier ESAQ406P 用户手册

1. Measure the width of the window opening. (See Fig.13)
2.  Mark the center line on the inside of the windowsill  

with a pencil. (See Fig.14)

•  Do not block the air discharge or air intake areas on the front panel.
•   Do not block the louvers on the outside of the air conditioner.
3.  Center the air conditioner in the window sill.  

Make sure to place the unit so that it is resting on the windowsill 
with a ¼" to ½" downward tilt towards the outside. Lower the 
window sash behind the top channel to hold the unit in place.  
(See Fig.15)

 

NOTE:  The appearance of your model may differ from the one 

shown.

4.  Loosen the screw located on the lower-right hand corner  

of the air conditioner.

5.  Slide the side bracket over the screw. The side bracket should be 

resting on the window sill. (See Fig.16)

6.  Partially tighten the screw. Secure the unit before tightening 

completely. 

7.  Use 1/8" drill bit to drill a starter hole through the holes in the side 

bracket.

8.  Using two (2) 1" wood screws, attach the side bracket to the 

window sill.

9.  Repeat for side bracket installation on the left-hand side of the air 

conditioner.

•  Be sure your air conditioner does not fall out of the window opening during installation  

or removal.

Fig. 13

Fig. 14

Fig. 16

WIDTH

LENGTH

HEIGHT

WIDTH

WIDTH

CENTER

WIDTH OF  
WINDOW OPENING

CENTER LINE

Top Channel

Lower Window Sash

Fig. 15