Sanyo SAP-KRV94EHDX 用户手册
16
Operation with the Remote Control Unit (continued)
6. QUIET Mode
QUIET Mode is used to reduce the fan sound of the indoor unit.
Press the QUIET button.
The
The
mark appears in the display.
To cancel, press QUIET button again.
•
In QUIET Mode, the fan rotates at a slower speed than the fan speed setting.
•
If the unit is already operating with a very low airflow, the fan sound may not
change even if the QUIET button is pressed.
change even if the QUIET button is pressed.
7. HIGH POWER Mode
HIGH POWER mode can be used to increase the output of the indoor unit for all
operation modes except automatic operation.
operation modes except automatic operation.
Press the HIGH POWER button.
The
The
mark appears in the display.
To cancel, press HIGH POWER button again.
•
When the HIGH POWER button is pressed, the unit operates at maximum output for
30 minutes, regardless of the desired temperature. The fan speed is 1 step above
“High”.
30 minutes, regardless of the desired temperature. The fan speed is 1 step above
“High”.
•
HIGH POWER Mode cannot be used when the operation mode is Automatic Operation.
•
QUIET Mode and HIGH POWER Mode cannot be used at the same time.
8. ION Mode
The ION mode is used during operation to generate negative ions that freshen up the
air in the room.
air in the room.
Press the ION button.
The
The
mark appears in the display.
To cancel, press ION button again.
•
The indoor unit’s ION lamp lights up while negative ions are being generated.
•
ION “on” is the remote control unit’s initial setting.
•
The negative ions are generated from the negative ion generator.
9. LED CLEAN Mode
In LED CLEAN mode, a UV anti-bacterial unit (including a LED CLEAN lamp and anti-
bacterial filter) in the indoor unit is used during AUTO, HEAT, DRY, COOL, or FAN
operation to remove bacteria from air blown from the air conditioner.
bacterial filter) in the indoor unit is used during AUTO, HEAT, DRY, COOL, or FAN
operation to remove bacteria from air blown from the air conditioner.
Press the LED CLEAN button.
The
The
mark appears in the display.
To cancel, press the LED CLEAN button again.
•
When the LED CLEAN button is pressed, the UV anti-bacterial unit operates for
one hour and cleans air blown from the air conditioner.
one hour and cleans air blown from the air conditioner.
•
•
When set to High fan speed during heating operation, the fan runs
at High fan speed even though the
at High fan speed even though the
mark is displayed.
•
Depending on the operating conditions, the fan speed may increase
by only a small amount.
by only a small amount.
NOTE
•
Pressing the MODE selector button cancels LED CLEAN mode.
•
Do not open the front panel while the LED CLEAN lamp on the
display is on.
display is on.
•
Depending on the room brightness, light from the LED CLEAN
lamp may reflect inside the air conditioner and be visible. This is
not a malfunction.
lamp may reflect inside the air conditioner and be visible. This is
not a malfunction.
NOTE
OI-791-16-EG
01_SAP-KRV94EHDX_EN.fm Page 16 Tuesday, August 30, 2005 6:41 PM