Toshiba RAS-07PKVP-E 用户手册

19

EN

As shown in Figure 1, Automatic Operation mode selects the operation based on the room temperature data when operation begins.

The operation mode is selected again after the compressor has remained stopped for 15 minutes.

When you press the Hi POWER button during cooling, heating or A operation, the air conditioner starts the following operation.

The cooling operation is performed at 1°C lower than the temperature setting.
The fan speed is also set to high*. 

* The noise level raises, according to the fan speed.

The heating operation is performed at 2°C higher than the temperature setting.
The fan speed is automatically switched according to the operating condition.

The air conditioner automatically controls the room temperature, air flow and noise level, to prevent overcooling in summer and 
maintain a warm and comfortable room in winter.

The dry mode automatically selects the cooling dry operation based on the difference between the temperature setting and the actual 
room temperature.
The fan speed indicator shows AUTO, and low speed is used.

• The display panel indicators will decrease in brightness in sleep mode.

• The power and noise level are reduced during sleep mode, so the room may not be cooled sufficiently if the mode is used for 

a long period of time.

• The sleep mode cannot be used during dry operation, PURE operation (independent operation).

(PURE operation (independent operation) is when the PURE button is pressed while the air conditioner is stopped to perform 
PURE operation by itself. The air conditioner does not operate at this time.)

• If the FAN button is pressed during sleep mode, the sleep mode is canceled.
• Sleep mode is not a timer operation.

Room temperature when operation begins 
or when selected again

Cooling operation 

Fan only operation

Heating operation 

Figure 1

Room temperature

Setting temperature+1

Setting temperature

Setting temperature–1