Raypak 0030B 用户手册

DANGER - SHOCK HAZARD
Make sure electrical power to the boiler is disconnect-
ed to avoid potential serious injury or damage to com-
ponents.

1.  Gas Valve Replacement

a) Shut-off electrical power and gas supply to the
     boiler.
b) Remove gas piping to gas valve inlet.
c) Disconnect wiring connections, pilot tubing
     (when present).
d) Remove screws (2) holding the  burner tray.
e) Slide burner tray out.
 f) Remove gas valve bracket screws and bracket.
g) Unscrew gas valve from gas pipe.
h) Reverse above procedure to re-install.

2.  Pilot Burner Cleaning or Replacement (Standing
     Pilot)

a) Shut-off electrical power and gas supply to the
    boiler.
b) Disconnect gas piping to gas valve.
c) Disconnect wiring connections to gas valve.
d) Remove screws (2) holding the burner tray.
e) Slide burner tray out.
 f) Remove screw holding pilot lighter tube.
g) Remove screws (2) holding pilot bracket on the
    burner tray.
h) Disconnect thermocouple and pilot tubing from
    the gas valve.
i) Remove pilot burner from pilot bracket.
j) Remove pilot orifice and blow away lint or dirt.
   Clean with wire or small brush.

NOTE: Make sure pilot orifice is clear, but do not

enlarge the hole.
k) Reverse above procedure to re-install.

3.  Flame Roll-out Switch Replacement

a) Shut-off electrical power to the boiler.
b) Remove wiring connections to switch.
c) Remove  screws (2) holding the switch.
d) Reverse above procedure to re-install.

4.  Vent Thermal Switch Replacement

a) Shut-off electrical power to the boiler.
b) Remove wiring connections to switch.
c) Remove the screws (2).
d) Reverse above procedure to re-install.

5.  Ignition Module Replacement

a) Shut-off electrical power to the boiler.
b) Remove control cover  screws and open control
    compartment.
c) Disconnect wiring connections to module.
d) Remove screws (2) holding module.
e) Reverse above procedure to re-install.

6.  Transformer Replacement

a) Shut-off electrical power to the boiler.
b) Remove control cover screws and open control
    compartment.
c) Disconnect wiring connections from trans-
    former leads.
d) Remove screws (2) holding transformer.
e) Reverse above procedure to re-install.

7.  Pump Relay Replacement

a) Shut-off electrical power to the boiler.
b) Remove control cover screws and open control
    compartment.
c) Disconnect wiring to the relay.
d) Remove screws (2) holding relay.
e) Reverse above procedure to re-install.

8.  High Limit Control

a) Shut-off electrical power to the boiler.
b)  Remove control cover  screws and open

control  compartment.

c) The control is factory set at 180°F.  To adjust to

setting, use a small screw driver and turn dial
clockwise           to lower the temperature or

counter-clockwise

to raise the setting.

d) To  replace the limit control, disconnect the wir-

ing connections.

e) Remove screws  (2) holding the limit control.
 f) Remove upper access panel.
g) Remove the wedge or retaining clip holding

the sensing bulb in the control well in the in/out
header.

h) Pull out the sensing bulb carefully from the

control well.

 i) Remove the limit control with capillary from

unit.

  j) Reverse above procedure to re-install.

33