Regency E33-LP 用户手册

E33 FPI Direct Vent Gas Insert

1)  Remove the rivets from the surround by 

pulling off the hoseclamp (located at the 
backside of surround) with a screwdriver or 
plyer. Re-install the rivets by putting them 
through the holes on the sides of the sur-
round. 

3)  Remove the handles by removing the nut 

and screw. Install the new handles by plac-
ing them in position over the holes on the 
surround louver. Put the screws through 
the holes and secure them by tightening 
them with a nut.

2)  Take the hoseclamps and put them over the 

back of each rivet. Squeeze the hoseclamp 
to secure onto rivets ensuring that the 
hoseclamp is touching the back side of 
the surround. The hoseclamp can now be 
released.

4)  Place the emblem over the emblem design 

on the surround. Insert the studs through the 
holes. To secure them fi rst put on the split 
lock washer and then the nut and tighten.

 

Remove the handles by removing the nut 
and screw. Install the new handles by plac-
ing them in position over the holes on the 
door(s). Put the studs through the holes 
and secure them by tightening them with a 
nut.

5)  Place the bottom hooks of the Surround into 

the bottom slots of the Faceplate. Slightly 
pull up the Surround and push the top hooks 
into the top slots of the Faceplate. Push 
down to secure. Tug on the Surround to 
ensure it is securely locked in place. 

5)  Remove the 2 studs on the sides of the Hood. 

Insert the new studs through the holes and 
secure them by fi rst putting on the washer 
and then tighten with a nut.

1)  Attach door bracket to sides using 4 

screws.

Double Screen Door: attach to left and right 
side of unit.

2)  Slide the door(s) onto the hinges.