Regency E33-NG 用户手册

E33 FPI Direct Vent Gas Insert

1)  Align the left side Faceplate Trim Bracket 

with the Firebox Flange and secure using 
2 screws as shown in diagram 1. Repeat 
for right side. 

IMPORTANT NOTE:
When using the Surround, the unit must be set 1" 
further into the fi replace than the standard face-
plate installation. See page 6 for the Minimum 
Fireplace Opening Excalibur Option. 

2)  Push the Blanking Plate down on top of the 

Glass Door (refer to Diagram 2).

6)  Place Bottom Frame near hinge. Flip hinge 

over Bottom Frame and secure with 3 screws 
each.

5)  Install Spring Hinges to the Left and Right 

Side of the bottom of the fi rebox using 2 
screws per hinge.

7)  Install the Left and Right Side Screen Doors 

by placing over top of the hinges on the 
faceplate. Hold the door at a 45 degree 
angle to avoid scratching the faceplate.

8)  Close screen doors.

3)  Hold the Faceplate Trim up against the unit 

in order to make the following wire connec-
tions.

3a) Pull the ON/OFF connector wires from the 

fi rebox and connect them to the switch.

3b) Connect the fan switch wires with the wire 

connectors from the fan speed control. Place 
clips over wires and tuck into side trim. 

for gas

connection

Self-adhesive
wire clip

ON/OFF

switch

wires to
ON/OFF
switch

wires to
Fan switch
connectors

Fan Speed
Switch
(Rear View)

4)  Secure the Faceplate by sliding the slots in 

the Faceplate into the fl anges on the left and 
right side Faceplate Trim Brackets. Once the 
Faceplate is in place secure using 2 screws 
per side.