Recoton/Advent U31-NG2 用户手册

FPI U31-2 Gas Fireplace Insert

1)  Place the bay door onto the 2 pins on the 

top of the unit.

2)  Install bottom louver by sliding the two 

bracket clips into the brackets located 
underneath the bay door and secure with 
2 screws into the bracket on the bottom of 
the Bay Front as per diagram above.

3)  Slide the valve extension knobs onto the 

valve knobs. match the correct ext. knob 
with the valve knob.

1)  Install top louver by sliding the two bracket 

clips into the brackets located on top of the 
bay door. See below. The fi tted louver leaves 
a small gap between faceplate bottom and 
louver top.

3)  Place the bottom of the fl ush glass behind 

the bottom glass trim. 

4)  Secure the glass with the two glass clips at 

the top corners of the glass. Secure glass 
clips with the screws provided. Do not over 
tighten as this could break the glass.

5)  Slide in the top glass trim under the spring 

clips. 

2)  Position 2 magnets on the back of each trim 

piece close to the ends.  Place the top and 
bottom trim  pieces on the bay front.  

 
3)  Install top and bottom louvers.

1)  Pull out the 

top louver 
and the top 
glass trim.

2) Loosen the 

screws so 
the glass 
c l i p s   c a n 
be turned 
aside and 
t h e   f l u s h 
g l a s s   r e -
moved.

1)  The Top Louver is held in place by friction 

fi t, if the Louver needs to be adjusted; bend 
the bracket out as shown in the diagram. 

2)  Install the Spring Hinges on the left and right 

side of the bottom of the Firebox using 2 
screws per hinge.

3)  Place the Bottom Louver near the hinge. Flip 

hinge over the Bottom Louver and secure 
using 3 screws.