Motorola MTX950 用户手册
5-4
Radio Tuning, Programming, Cloning, Lowband Antenna Cutting Procedure, PassPort Tone Options, and Diagnostic Functions
source radio produces a “clone-exit” tone and displays “Clone Complete”.
7.
Turn both radios off.
8.
Disconnect the cloning cable from both radios and turn them on for normal operation.
Figure 5-3: Radio Side Button Locations
Figure 5-4: HT1550•XLS Radio Side Button Locations
5.4.1 Error Codes (Display Radios Only)
l
“ERR: Mismatch” - The model numbers or the code plug versions are not the same for both
radios. Cloning cannot be performed.
radios. Cloning cannot be performed.
l
“ERR: Timeout” - Communication between the two radios was not established or was disrupted
during the cloning process. If this occurs, check the cloning cable and all connections. Repeat the
cloning procedure.
during the cloning process. If this occurs, check the cloning cable and all connections. Repeat the
cloning procedure.
5.5
Cloning (Privacy Plus)
This function is used to copy codeplug information from one radio to another. A radio and RIB must be
properly connected to the computer and power turned on before you attempt the PROGRAM function.
The time required to PROGRAM a codeplug will depend on the computer and the size of the
codeplug you are programming. Only radios with the same model number, protocol option and
codeplug version may be cloned. Trunked radios may not be cloned unless System Keys have been
loaded for each trunking system ID. Tuning and alignment information are not transferable and are
not affected by cloning. Signalling Identification are duplicated in the cloning process. Unique IDs may
be assigned with the CPS.
properly connected to the computer and power turned on before you attempt the PROGRAM function.
The time required to PROGRAM a codeplug will depend on the computer and the size of the
codeplug you are programming. Only radios with the same model number, protocol option and
codeplug version may be cloned. Trunked radios may not be cloned unless System Keys have been
loaded for each trunking system ID. Tuning and alignment information are not transferable and are
not affected by cloning. Signalling Identification are duplicated in the cloning process. Unique IDs may
be assigned with the CPS.
Side Button 1
Side Button 2
Side Button 3
On/Off
Knob
(programmable)
(programmable)
(programmable)
Side Button 1
Side Button 2
Side Button 3
On/Off
Knob
(programmable)
(programmable)
(programmable)