Lightolier 402MRIC9X 产品宣传页

 

4 3/4" (121mm)

Accepts all 4 3/4" (121mm) Low Voltage MR16 trims 400 series: see

Reflector Trim specification sheets.

Mounting Frame : 20ga. galvanized steel. Four slots are positioned  90º

apart to simplify alignment.

20" (508mm) long. Set of 2

Insulated Ceiling Housing : 26ga. galvanized steel. CSA certified and UL listed for 
direct contact with thermal insulation.

Internal thermal cut-out : insures against overheating due to incorrect lamping.  

To lock mounting bars in place after installation. Set of 12.

Mounting Bars: (4) 18 ga. galvanized steel. 13" (330mm) long bars extend to
27" (686mm), rotatable and lockable, integral T-bar tabs. Spike detail

eliminates the need of additional nailing. 

Polyvinyl Air Vapour Barrier ; to comply with provincial legislation. For all

Mounting Bars Locking Clip : (1) locks mounting bars in place. 

non Air-Seal frame-In-Kits.

Socket :  Porcelain body ; Two-pin (GX5.3 base) Pre-wired with 18 ga. Teflon
250º leads to junction box. 
Transformer : 75VA Magnetic, 120 volt primary, nominal 12 volt secondary, 
class "H".  
Junction Box : 4"(102mm) x 3"(76mm) x 2"(51mm) 18 ga. galvanized steel .
CSA/UL certified for maximum of  8 No. 12 ga. 90º C through branch circuit
conductors. Integral cable clamp permit attachment of  non metallic Loomex

without need of additional connectors. Pry-out knock-outs accept BX cable.
Easy access from both sides with snap-on covers.

Damp or Wet location rated depending on trim used.

WE RESERVE THE RIGHT TO CHANGE DETAILS OF DESIGN,  MATERIALS AND FINISH, IN ANY WAY

THAT WILL NOT ALTER INSTALLED APPEARANCE OR REDUCE FUNCTION AND PERFORMANCE.