Lightolier 402MREX 产品宣传页

 

4 3/4" (121mm)

Accepts all 4 3/4" (121mm) Low Voltage MR16 trims 400 series: see

Reflector Trim specification sheets.

Mounting Frame : 20ga. galvanized steel. Four slots are positioned  90º

apart to simplify alignment.

20" (508mm) long. Set of 2

Mounting Bars: (4) 18 ga. galvanized steel. 13" (330mm) long bars extend to
27" (686mm), rotatable and lockable, integral T-bar tabs. Spike detail

eliminates the need of additional nailing. 

To lock mounting bars in place after installation. Set of 12.

Mounting Bars Locking Clip : (1) locks mounting bars in place. 
Snap-on Socket Cup : 22ga. galvanized steel. Easy snap-on to housing.
Socket :  Porcelain body ; Two-pin (GX5.3 base) Pre-wired with 18 ga. Teflon
250º leads to junction box. 
Transformer: Electronic, 75W, 120 volt primary, 11.75 volts output at max. load.
RFI protection compatible with FCC limits.
Junction Box : 4"(102mm) x 3"(76mm) x 2"(51mm) 18 ga. galvanized steel .
CSA/UL certified for maximum of  8 No. 12 ga. 90º C through branch circuit
conductors. Integral cable clamp permit attachment of  non metallic Loomex
without need of additional connectors. Pry-out knock-outs accept BX cable.
Easy access from both sides with snap-on covers.

Thermal Protector : Meets CSA/UL requirements. Insulation, if used, must 
be kept 3" (76mm) away from luminaire sides and junction box.

Damp or Wet location rated depending on trim used.

 

WE RESERVE THE RIGHT TO CHANGE DETAILS OF DESIGN,  MATERIALS AND FINISH, IN ANY WAY

THAT WILL NOT ALTER INSTALLED APPEARANCE OR REDUCE FUNCTION AND PERFORMANCE.