Regency CS1200 用户手册

Regency CS1200  Freestanding Wood Stove

1)  If the two air tubes are installed continue on to Step 2), if not, follow the 

instructions below. Install the air tube into the holes in the side channels. 
The notch goes on the right hand side with the air holes facing toward the 
door. Slide the tube into the left hand side, as far as possible and then 
bring it back into the hole on the right hand side until it locks into position. 
If the tube will not slide in easily simply use a pair of vise grips or pliers 
and tap it into place with a hammer. A tighter fi t will ensure the tube will 
not move when the unit is burning. Refer to the Mobile Home Installation 
section, though there are only two air tubes in the small units.

2)  Slide the left baffl e brick over the front air tube and then slide it back over 

the rear air tube.

3)  Tilt the left baffl e brick up on top of the side channel and it will leave enough 

room to position the right baffl e brick in the same manner as Step 1 above. 
Then reposition the left baffl e brick fl at on the air tube. 

The door handle can be removed and stored on a hanger located on the  
inside left in the wood storage area.

Firebrick is included to extend the life of your stove and radiate heat more 
evenly.  Check to see that all fi rebricks are in their correct positions and have 
not become  misaligned during shipping.

The "AD" brick in the drawings above is the brick covering the Ash Dump hole 
that is used when the Ash Drawer Kit is installed.