Regency CS1200 用户手册

Regency CS1200  Freestanding Wood Stove

During constant use, ashes should be removed 
every few days. The  Ash Drawer option features 
a convenient ash dump for easy removal of ash, 
refer to the "Modular Options" section.

1)  Do not allow ashes to build up to the loading 

doors!  Only remove ashes when the fi re has 
died down.  Even then, expect to fi nd a few hot 
embers.

2)  Please take care to prevent the build-up of ash 

around the start-up air housing located inside 
the stove box, under the loading door lip.

3)  Never start a fi re if the ash plug and ash drawer 

are not in place. This will cause overfi ring which 
can cause excessive warping of the stove. 
Evidence of overfi ring can void the warranty 
on your stove.

4) The 

fi rebricks are brittle and can be damaged 

if the plug is replaced carelessly or pieces that 
are too large are forced through the hole. 

1)  Only clean ashes out of the stove when the 

stove is cold.  Remove the plug by lifting on the 
handle using the tool provided. Push the ashes 
down the hole into the ash drawer, the large 
pieces can be left in the fi rebox and burned 
during the next fi re or removed through the 
door opening.

2)  Always leave 1/2 to 1 inch of ash in the bottom 

of the fi rebox.  This helps in easier starting and 
a more uniform burn of your fi re. Replace ash 
plug when ashes have been removed.

3)  Open the lower surround door by hooking two 

fi ngers in the slot near the left side - pull open 
towards the right.

4)  When emptying the ash drawer, make sure 

the ashes are cold. Ashes should be placed 
in a metal container with a tight fi tting lid.  The 
closed container of ashes should be placed on 
a non - combustible fl oor or on the ground, well 
away from all combustible materials, pending 
fi nal disposal.  If the ashes are disposed of by 
burial in soil or otherwise locally dispersed, they 
should be retained in the closed container until 
all cinders have thoroughly cooled.  Other waste 
should not be placed in the ash container.

5)  Before putting the ash drawer back into place, 

make sure the ash plug is back in place.